Search results

Confirmed bed is more or less level ...nted out the fill rate was too high... the 20mm block was bowed out on the top. cut it back to .95 in the extrusion multiplier in slic3r. Better, still to

In pronterface in the top left corner, near the big concentric circles, go ahead and hit the X home a ...are JUST ABOVE or JUST TOUCHING the glass. You need a clean extruder and a level bed for this to work well, but you'll find with some practice what is 'acce

...s at Knox Makers, set expectations for each type, as well as the scope and level of effort of each of those presentations. ...t Knox Makers: classes and workshops. The difference is the participation level of the audience, and are defined as follows:

...e without having to very closely tend it to keep it at just the right fire level. When I'm not drawing air into the smoker, it will just exhaust out the ch Then we made two identical frames, one each for the top and bottom:

#Members may not store anything on top of the member storage shelving. ...y 4 feet by 3.5 feet high. Each rack will hold two rental spaces at floor level, and two rental spaces elevated.

#Members may not store anything on top of the member storage shelving. ...y 4 feet by 3.5 feet high. Each rack will hold two rental spaces at floor level, and two rental spaces elevated.

...conductive paint. An alternate cheap solution could be arrows cut out of a top layer of cardboard and aluminum foil patches taped to line up with the arro ...y. This can help to take, for instance, a cardboard project up to the next level with a nice little "cool" factor. A cardboard guitar with some actual butto