MendelMax Build Notes - Revision history

Laz: moved Mendel Max Build Notes to MendelMax Build Notes: misspelled title.

2013-05-05T15:15:31Z

moved Mendel Max Build Notes to MendelMax Build Notes: misspelled title.

← Older revision		Revision as of 15:15, 5 May 2013
(No difference)

Laz at 17:48, 20 January 2013

2013-01-20T17:48:25Z

← Older revision		Revision as of 17:48, 20 January 2013
Line 1:		Line 1:
	Notes from the Mendel Max Build, Jan 19, 2013:		Notes from the Mendel Max Build, Jan 19, 2013:
	Actions performed:		Actions performed:
	*Tapping all of the Al extrusions took considerable time. Everyone should be tapping together, or the pieces should be untapped. Note: This step could, and perhaps should be performed ahead of time if we have a larger class. Tapping one set takes approximately 1 hour for one set.		*Tapping all of the Al extrusions took considerable time. Everyone should be tapping together, or the pieces should be untapped. Note: This step could, and perhaps should be performed ahead of time if we have a larger class. Tapping one set takes approximately 1 hour for one set. Use power taps with a cordless screwdriver in the future.
	*The heated platforms needed the lead wires soldered on. This step takes approximately 15 minutes per kit to strip the wires, tin them, and solder them to the build platform.		*The heated platforms needed the lead wires soldered on. This step takes approximately 15 minutes per kit to strip the wires, tin them, and solder them to the build platform.
	*The steel rods for the bearings needed to be cut and finished. It took approximately 1.5 hours to do this for ~~three~~ printers.		*The steel rods for the bearings needed to be cut and finished. It took approximately 3.5 hours to do this for four printers.
	*Loading firmware to the Arduino boards was the next step.		**Use a hacksaw for cutting.
			**Use lathe to end finish and cut chamfer.
			*Loading firmware to the Arduino boards was the next step. Step takes approx 1 min per board.
			*Two pieces of Al extrusion per kit need to be marked, punch, center drilled and drilled with through holes. This took about an hour for four kits. Setup time takes most of the time for this effort.
			*Soldering limit switches together as a prep work. It took about an hour for three kits.
			*Cutting MDF for bed support. There is a lot of setup and cleanup time. Only a few minutes of actual cutting per set is required.

Laz: Created page with "Notes from the Mendel Max Build, Jan 19, 2013: Actions performed: *Tapping all of the Al extrusions took considerable time. Everyone should be tapping together, or the pieces sh..."

2013-01-19T16:09:12Z

Created page with "Notes from the Mendel Max Build, Jan 19, 2013: Actions performed: *Tapping all of the Al extrusions took considerable time. Everyone should be tapping together, or the pieces sh..."

New page

Notes from the Mendel Max Build, Jan 19, 2013:
Actions performed:
*Tapping all of the Al extrusions took considerable time. Everyone should be tapping together, or the pieces should be untapped. Note: This step could, and perhaps should be performed ahead of time if we have a larger class. Tapping one set takes approximately 1 hour for one set.
*The heated platforms needed the lead wires soldered on. This step takes approximately 15 minutes per kit to strip the wires, tin them, and solder them to the build platform.
*The steel rods for the bearings needed to be cut and finished. It took approximately 1.5 hours to do this for three printers.
*Loading firmware to the Arduino boards was the next step.