FlySky Configuration

Function	Description	Steps	Video
Factory Reset	If you're using one of the shop controllers for the first time you may wish to factory reset it in order to clear the previous user's customizations. ** BEFORE proceeding review the Bind Transmitter and Receiver section below! If you don't have a Binding Plug you may not be able to re-connect your Transmitter and Receiver!	Turn on the transmitter. Press and hold the OK button to enter the System Menu. Use the UP/DOWN buttons to scroll to “System”. Press OK to enter. Scroll to “Factory Reset”. Press OK. Select “YES” to confirm the reset.
Bind Transmitter and Receiver	If you've factory reset your Transmitter if may be necessary to re-bind it to your receiver. You'll need a	Put the receiver in bind mode Insert the bind plug into the receiver port labeled B/VCC. Power the receiver (plug battery or ESC power into another channel like CH3). The receiver LED should flash quickly, meaning it’s in bind mode. Put the transmitter in bind mode Turn off your FS-i6X. Hold the “BIND KEY” button on the back of the transmitter. While holding it, turn the transmitter on. The screen will show “RX Binding”. After a few seconds the receiver LED should stop flashing and turn solid. This means the transmitter and receiver are successfully bound.
Configure Single Stick Mode	As discusses	Hardware Steps: Plug left motor ESC → CH1 Plug right motor ESC → CH2 On the transmitter go to Functions Setup → Elevon Turn Elevon mixing ON Configuration Steps: Press and hold the 'OK' key 'til the 'MENU' screen appears. Tap the 'Down' key to highlight 'Functions setup' -- tap 'OK' to select. Use the 'Down' key to scroll down the list to 'Elevon' -- tap 'OK' to select. Tap the 'Down' key to turn Elevon 'On'. Use the 'OK' key to scroll to 'CH2', then the 'Up' key to set it to 100%. Leave 'CH1' at 50%. Press and hold 'Cancel' to exit and save the Elevon settings. Tap 'Cancel' to return to the 'MENU' screen.