Optical Communication in Free Space: Difference between revisions

From Knox Makers Wiki
Jump to navigation Jump to search
No edit summary
Line 36: Line 36:


==Receiver==
==Receiver==
A CdS photoresistor seems like the best option.
http://www.token.com.tw/pdf/resistor/cds-resistor-pgm.pdf
Models are available with a spectral peaks at 540 nm or 560 nm.  Our green laser pointer emits light at close by at 532 nm for a relative sensitivity between 80 and 90 percent, so the 540 nm models are recommended.  It's a nice coincidence that our emission spectrum matches closely to the receiver spectral peak.
Rise response times are typically 20 or 30 ms and decay response times are typically 30 or 40 ms.


=Legal & Safety=
=Legal & Safety=

Revision as of 16:18, 7 April 2011

Overview

Forum Link http://www.knoxvillehackerspace.com/phpbb/viewtopic.php?f=6&t=13

Milestones

Range

  • Demonstrate point to point communications across a room with Class IIIa lasers and no receiver optics
  • Demonstrate point to point communications across a field with Class IIIa lasers and receiver optics present
  • Determine distance limitations of point to point communications using Class IIIa lasers
  • Procure Class IIIb lasers and necessary protective gear and attempt longer range communications

Data Transfer

Half Duplex

  • Go/No Go with simple breadboard circuit
  • Simple voice communication with modulator and amplifier circuits
  • High speed network communications

Full Duplex

  • Go/No Go with simple breadboard circuit
  • Simple voice communication with modulator and amplifier circuits
  • High speed network communications

Optics

Transmitter

LEDs

LEDs have been demonstrated

Lasers

The potential advantage of using a commercial laser pointer over over an optically enhanced LED is the lack of the additional optics assembly.

A 5 mW green laser pointer is available from http://www.optotronics.com/green-laser-pointers.php with very good beam properties Beam divergence: <1.2 mrad Beam diameter: <1.5 mm

  • Add equations for divergence and maybe wolfram alpha application for calculations

  • Calculate power density and compare with RONJA results

Receiver

A CdS photoresistor seems like the best option. http://www.token.com.tw/pdf/resistor/cds-resistor-pgm.pdf Models are available with a spectral peaks at 540 nm or 560 nm. Our green laser pointer emits light at close by at 532 nm for a relative sensitivity between 80 and 90 percent, so the 540 nm models are recommended. It's a nice coincidence that our emission spectrum matches closely to the receiver spectral peak. Rise response times are typically 20 or 30 ms and decay response times are typically 30 or 40 ms.

Legal & Safety

Code of Federal Regulations Title 21 Section 1040 [1]

OSHA Technical Manual Section III Chapter 6 Laser Hazards [2]

ANSI Z136.1 (2007) - Safe Use of Lasers

ANSI Z136.6 (2005) - Safe Use Of Lasers Outdoors

http://en.wikipedia.org/wiki/Laser_safety

External Links

RONJA (Reasonable Optical Near Joint Access) Project Homepage http://ronja.twibright.com/

http://en.wikipedia.org/wiki/RONJA

http://members.misty.com/don/laserfaq.htm

http://www.repairfaq.org/sam/laserdps.htm

http://captain.haddock.8m.com/laser/laser1.html

http://en.wikipedia.org/wiki/Free-space_optical_communication