Shane's printer notes

Started 2/20 with whatever the default config stuff is on the printer

used default slicer config, Marlin configs from github

When Zing, notice that front left clip interferes with fan. WTF... fan? Clips interfere with complete bed... don't even get 180x180. Need a better means. Remove fan? Removed.

Reset the switches for X and Z homes to be 'correct'. Confirmed 30mm extrusion is more or less 30 mm (accuracy suffers w/ inches tape measure, need metric) Confirmed bed is more or less level

following instructions from here: http://richrap.blogspot.com/2012/01/slic3r-is-nicer-part-1-settings-and.html

printed .5mm box, isnt great... poor 1st layer adhesion, messy walls

adjusted the speeds per calibration instructions part 2

reset to default firmware / config reprinted calibration box... X axis is reversed. endstops dont work. Considerably different from stock! Restored previous firmware.

JHEAD hotend? What nozzle size?

"So as a refresher you need to set the correct steps per mm of used filament in the firmware, you can work this out by just extruding some plastic, I recommend using Printrun (Pronterface) Get it here

To do this you will need to edit, re-compile and upload firmware to your electronics, I'm going to assume you already know how to do that using the Arduino software. - (If not let me know)."