Shane's printer notes: Difference between revisions
No edit summary |
No edit summary |
||
| Line 2: | Line 2: | ||
used default slicer config, Marlin configs from github | used default slicer config, Marlin configs from github | ||
When Zing, notice that front left clip interferes with fan. WTF... fan? Clips interfere with complete bed... don't even get 180x180. Need a better means. Remove fan? Removed. | |||
following instructions from here: | following instructions from here: | ||
http://richrap.blogspot.com/2012/01/slic3r-is-nicer-part-1-settings-and.html | http://richrap.blogspot.com/2012/01/slic3r-is-nicer-part-1-settings-and.html | ||
JHEAD hotend? | |||
"So as a refresher you need to set the correct steps per mm of used filament in the firmware, you can work this out by just extruding some plastic, I recommend using Printrun (Pronterface) Get it here | |||
To do this you will need to edit, re-compile and upload firmware to your electronics, I'm going to assume you already know how to do that using the Arduino software. - (If not let me know)." | |||
Revision as of 15:30, 20 February 2013
Started 2/20 with whatever the default config stuff is on the printer
used default slicer config, Marlin configs from github
When Zing, notice that front left clip interferes with fan. WTF... fan? Clips interfere with complete bed... don't even get 180x180. Need a better means. Remove fan? Removed.
following instructions from here: http://richrap.blogspot.com/2012/01/slic3r-is-nicer-part-1-settings-and.html
JHEAD hotend?
"So as a refresher you need to set the correct steps per mm of used filament in the firmware, you can work this out by just extruding some plastic, I recommend using Printrun (Pronterface) Get it here
To do this you will need to edit, re-compile and upload firmware to your electronics, I'm going to assume you already know how to do that using the Arduino software. - (If not let me know)."