Nibblerbot/tools/tool 99: Difference between revisions
From Knox Makers Wiki
No edit summary |
|||
| Line 31: | Line 31: | ||
- '''Recommended Speeds and Feeds''': | - '''Recommended Speeds and Feeds''': | ||
- '''RPM''': 0 | - '''RPM''': 0 | ||
- '''Feed Rate''': 2 / 50 | - '''Feed Rate''': 2 ipm slow feed rate / 50 ipm fast feed rate | ||
==Additional Notes== | ==Additional Notes== | ||
*Additional probe stylus are available in the toolbox. The steel 2mm Ø is installed and probe is calibrated. Do not change the stylus without checking with Czar or Deputy Czar | *Additional probe stylus are available in the toolbox. The steel 2mm Ø is installed and probe is calibrated. Do not change the stylus without checking with Czar or Deputy Czar | ||
*This is the Normally closed NPN version of the probe. Transistor circuit needed to work with MESA 7i76e | |||
*Has a USB-C to 1/8 TSR connector. | |||
*Will show as tipped if the USB-C is not plugged into the probe. | |||
*Do not exceed 50ipm rapid with probe. | |||
Revision as of 07:36, 11 December 2024
Tool 99 - Wired Touch Probe
| Attribute | Details |
|---|---|
| Tool # | 99 |
| Tool Type | Touch Probe |
| Flutes (FL) | N/A |
| Overall Length (OAL) | N/A |
| Length of Cut (LOC) | N/A |
| Diameter | 2mm Ø - Tip |
| Material | N/A |
| Coating | N/A |
| Manufacturer | PGFUN |
| Image or CAD |
 |
| Order Link | [Click here to purchase this tool] |
Usage Information
- Recommended Speeds and Feeds:
- RPM: 0 - Feed Rate: 2 ipm slow feed rate / 50 ipm fast feed rate
Additional Notes
- Additional probe stylus are available in the toolbox. The steel 2mm Ø is installed and probe is calibrated. Do not change the stylus without checking with Czar or Deputy Czar
- This is the Normally closed NPN version of the probe. Transistor circuit needed to work with MESA 7i76e
- Has a USB-C to 1/8 TSR connector.
- Will show as tipped if the USB-C is not plugged into the probe.
- Do not exceed 50ipm rapid with probe.
