Laser Cutter

From Knox Makers Wiki
Revision as of 04:53, 20 October 2012 by Andronicus (talk | contribs)
Jump to navigation Jump to search

Theory / General Info

Laser

Optics

Linear Motion

Electronics

  • Potential arduino shield to use with LasaurGrbl - LasaurShield

Software

  • Potential controller software based on Grbl- LasaurGrbl
  • Software to run on Mac/PC to send G-code to LasaurGrbl - LasaurApp

Build Notes

  • The laser cutter being built is based around the laser cutter on Buildlog.net
  • Another good reference is Lasersaur

To Do List

  • Buy/build shaft couplers for y-axis
  • Buy honeycomb surface
  • Buy large z-axis gear
  • Buy Pololu motor drivers --Andronicus 00:50, 20 October 2012 (EDT)
  • Buy Pololu heat sinks
  • Specify limit switches
  • Buy limit switches
  • Cut 1/4" aluminum rod stock to 12" & 14" sections for y-axis shafts
  • Machine air assist nozzle
  • Build roll around table
  • Determine electronics setup