Convert Laser: Difference between revisions
Jump to navigation
Jump to search
| Line 38: | Line 38: | ||
|} | |} | ||
= | =Implementation= | ||
The wiring diagram, design files for the panels, and LinuxCNC config can be found on our github in the [https://github.com/KnoxMakers/Moonraker Moonraker Repository] | |||
.. in progress .. | .. in progress .. | ||
Revision as of 02:08, 2 February 2020
The purpose of this page is to document the conversion of our Chinese laser to use our preferred firmware, LinuxCNC.
Importing
See our page on importing the laser.
Why
Changing the firmware gives us a few advantages.
- As an organization, we strongly value open source and this gives us the option of using a full open source stack to go from design to cut.
- We have years of experience, training, and development on the current stack and have had a really positive experience with it.
Plan
The plan is to remove the controller and display panel that came with the laser and replace them with a computer running LinuxCNC, a I/O card, and a panel of our own design and needs. Our goal is to fit this all into in the new laser using the existing structure in a neat and beautiful way.
Software
| Inkscape | Design Optionally, our KM-Laser Bundle |
| Custom Web interface | Upload to laser + CAM Name and link coming |
| LinuxCNC | Firmware to run laser |
Hardware
| Computer | Gigabyte-J1900N-D3V 4GB SODIMM Parallel Port Card |
| Break Out Board | C10 Parallel Port Breakout Board |
Implementation
The wiring diagram, design files for the panels, and LinuxCNC config can be found on our github in the Moonraker Repository
.. in progress ..