Laser Operation Class: Difference between revisions

From Knox Makers Wiki
Jump to navigation Jump to search
No edit summary
mNo edit summary
 
Line 1: Line 1:
Only Knox Makers members are allowed to use the laser cutter, and only after taking the Laser Cutter Workshop.  You can look on our [https://knoxmakers.org/events/ events calendar] to see if any are scheduled, or talk to the [https://knoxmakers.org/member/jondale/ Laser Cutting Czar].  The cost of the class is $10 and lasts about 2 hours.  This class provides an overview of the machine itself, a short tutorial in Inkscape, what materials you can and can't use, and basics of operation.  It will also include a hands-on demo of how to power up and power down the machine.
Only Knox Makers members are allowed to use the laser cutter, and only after taking the Laser Cutter Workshop.  You can look on our [https://knoxmakers.org/events/ events calendar] to see if any are scheduled, or talk to the [https://knoxmakers.org/member/jondale/ Laser Cutting Czar].  The cost of the class is $10 and lasts about 2 hours.  This class provides an overview of the machine itself, a short tutorial in Inkscape, what materials you can and can't use, and basics of operation.  It will also include a hands-on demo of how to power up and power down the machine.
There are no prerequisites for taking this class.
There are no prerequisites for taking this class.





Latest revision as of 14:59, 18 April 2017

Only Knox Makers members are allowed to use the laser cutter, and only after taking the Laser Cutter Workshop. You can look on our events calendar to see if any are scheduled, or talk to the Laser Cutting Czar. The cost of the class is $10 and lasts about 2 hours. This class provides an overview of the machine itself, a short tutorial in Inkscape, what materials you can and can't use, and basics of operation. It will also include a hands-on demo of how to power up and power down the machine. There are no prerequisites for taking this class.


Class Outline


Checklist for machine usage

Each of these steps will be covered in the Laser Cutter Workshop. Only members who have taken the class are authorized to use the laser cutter.

  1. Upload G-code to machine
  2. Power on laser cutter
  3. Power on filtration unit
  4. Start LinuxCNC
  5. Software E-Stop is off
  6. Software Machine Power on
  7. Machine Homed
  8. Load G-Code into LinuxCNC
  9. Align material
  10. Make sure Laser is in auto mode
  11. Make sure chiller is powered on
  12. Make sure lid closed
  13. Make sure E-stop is disengaged
  14. Arm switch
  15. Press play

Powering down machine

  1. Disarm switch
  2. Close LinuxCNC
  3. Turn off filtration unit
  4. Turn off power to laser cutter
  5. Do not power down computer!